Table of Contents
Advertisement
en operation
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press Start Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 28
¡ The programme end time is set
and activated.
→ "Buttons", Page 22
Press Start Reload.
1.
The activated programme end time
is paused.
Press Ready in until the display
2.
shows the required programme
end time.
Press Start Reload.
3.
The changed programme end time
is activated.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Start Reload.
1.
The appliance pauses.
30
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start Reload.
5.
13.11 Cancelling the pro-
gramme
Press Start Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 23
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→ "Buttons", Page 22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
Set the Spin programme or a pro-
1.
gramme for draining the water.
→ "Programmes", Page 23
Press Start Reload.
2.
Advertisement
Table of Contents
