Setup
Indicator
Red, blinking
Green,
blinking slowly
Repeating
pattern of
blinking green
and blinking
red
*1
The LED lights for about 2
seconds after a button is pressed,
then turns off. If the LED indicator
does not light when you press a
button, the battery must be
replaced.
*2
The LED indicator does not
indicate remote's status if the
remote has not been registered
(page 10).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the battery
The remote is battery powered.
3
Registration
Required only if the remote was
purchased separately (i.e., not as
part of a bundle).
8
HNK102C_(en_en)_0722_ver.011.pdf
Status
Remote is out of
range of the hub, or
could not
communicate with
the hub
Registration mode
(you pressed and
held M
N)
Low battery
For assistance, visit www.panasonic.ca/english/support
8
4
Confirm the usage area
Read the information in this
document to confirm that the
desired usage area is suitable to
proper operation.
2015/07/22
11:04:19