Panasonic NN-L750WB Service Manual page 38

3. When replacing faulty switches, be sure the mounting tabs are
not bent, broken or deficient in their ability to hold the switches.
8.5. Avoid inserting nails, wire etc. through any holes in the unit
during operation.
Never insert a wire, nail or any other metal object through the lamp holes on the cavity or any
holes or gaps, because such objects may work as an antenna and cause microwave leakage.
8.6. Confirm after repair
1. After repair or replacement of parts, make sure that the screws of
the oven, etc. are neither loose nor missing. Microwaves might
leak if screws are not properly tightened.
2. Make sure that all electrical connections are tight before inserting
the plug into the wall outlet.
3. Check for microwave energy leakage. (Refer to procedure for
measuring microwave energy leakage).
CAUTION MICROWAVE RADIATION
DO NOT BECOME EXPOSED TO RADIATION FROM THE
MICROWAVE GENERATOR OR OTHER PARTS CONDUCTING
MICROWAVE ENERGY
IMPORTANT NOTICE
The following components have potentials above 250V while is
appliance is operated.
- Magnetron
- High voltage transformer (Located on inverter (U))
- High voltage diodes (Located on inverter (U))
- High voltage capacitors (Located on inverter (U))
Pay special attention in these areas.
When the appliance is operated with the door hinges or magnetron
fixed incorrectly, the microwave leakage can reach more than 5mW/
cm . After repair or exchange, it is very important to check if the
3
magnetron and the door hinges are correctly fixed.
8.7. Sharp Edges
Caution
Please use caution when unpacking, installing or moving the unit,
as some exposed edges may be sharp to touch and cause injury if
not handled with care.
38