Lenovo ThinkServer RD220 3797 Series Installation And User Manual page 60

Note: The illustrations in this document might differ slightly from your hardware.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server and all peripheral devices are turned off and that the
3. Reinstall any adapters and reconnect any internal cables that you removed in
4. Align the PCI riser-card assembly with the selected PCI riser connector on the
5. Press down on the assembly. Make sure that the riser-card assembly is fully
44
ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide
1
PCI riser-card assembly 2
2
PCI riser-card assembly 1
3
Alignment slots
4
Alignment brackets
5
PCI riser connector 1
6
PCI riser connector 2
on page 33.
power cords and all external cables are disconnected.
other procedures (see "Internal cable routing and connectors" on page 38).
system board:
v PCI riser connector 1: Carefully fit the two alignment slots on the side of the
assembly onto the two alignment brackets in the side of the chassis.
v PCI riser connector 2: Carefully align the bottom edge (the contact edge) of
the riser-card assembly with the PCI riser connector on the system board.
seated in the riser-card connector on the system board.