Table of Contents
Advertisement
4.35 Use Philips EasyLink
Get the most out of your HDMI-Consumer
Electronic Control (CEC) compliant devices
with Philips EasyLink enhanced control
features.
If your HDMI-CEC compliant devices are
connected through HDMI, you can control
them at the same time with your TV remote
control.
To enable Philips EasyLink, you need to:
•
Connect HDMI-CEC
compliant devices through HDMI
•
Configure each HDMI-CEC compliant
device properly
•
Switch on EasyLink
Note
•
The EasyLink-compliant device must be
switched on and selected as the source.
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
4.36 Switch on or off EasyLink
When you play an HDMI-CEC compliant
device, the TV switches on from standby, and
switches to the correct source.
Note
•
If you do not intend to use Philips EasyLink,
switch it off.
Press
1
Select [Setup] > [TV settings] >
2
[EasyLink] > [EasyLink]
Select [On] or [Off ] , then press OK
3
Note
•
If EasyLink is OFF, all its submenus are
unavailable.
.
4.37 Switch the device ON or OFF
When an HDMI-CEC compliant device
is connected and TV switches to standby,
the device gets turned OFF automatically.
Press
1
Select [Setup] > [TV settings] >
2
[EasyLink] >
Select [On] or [Off ] , then press OK
3
[Auto Device OFF]
EN
19
Advertisement
Table of Contents
