Sylvania SY620 Manual

INTRODUCTION
Your Sylvania Simulated Security Dome Camera
is an affordable and effective theft deterrent
device. It looks like a real surveillance camera
with its flashing red indicator and dome
construction. You can mount the simulated
security camera in a visible area on a ceiling to
deter possible thieves and intruders.
Your simulated security camera comes with a
wall/ceiling mount plate, two screws and two dry
wall anchors.
INSTALLING BATTERIES
Your simulated security camera requires two "C"
batteries (not supplied) for power.
Cautions:
• Use only fresh batteries of the required size and
recommended type
• Do not mix old and new batteries, different types
of batteries (standard, alkaline, or rechargeable),
or rechargeable batteries of different capacities
Follow four steps to install batteries:
1. Open the dome camera by twisting off the
mounting base plate
-
-
2. Unscrew the battery compartment.
3. Place the batteries in the compartment
as indicated by the polarity symbols
(+ and -) marked inside.
4. The red indicator at the top of the dome
camera will flash.
MODEL – SY620
Simulated (Dummy) Dome Camera
Mounting
Base Plate
Battery
Compartment
Fresh batteries will power the simulated security
camera's indicator for about 4 months. When the
indicator dims or stops flashing, replace the
batteries
Warning: Dispose of old batteries promptly and
properly. Do not burn or bury them
Caution: If you do not plan to use the simulated
security camera with batteries for a month or
more, remove the batteries. Batteries can leak
chemicals that can destroy electronics parts
INSTALLING THE SIMULATED DOME
SECURITY CAMERA
1. Using the mounting base plate as a template,
use a pencil to mark the position of the two
screw holes on the mounting location
2. Drill two 1 inch holes in the marked positions
3. If necessary, insert the two supplied
drywall anchors into the screw holes
4. Insert a 1 inch screw through each
of the two screw holes in the mounting base
plate and into the mounting surface, then
tighten the screws.
5.Twist the top of the dome camera (with the
batteries installed) onto the base plate