Art DTRACK3 User Manual page 173

Please refer to chapter A.1 on page 187 for a list of supported operating systems
and communication ports.
Why is the Monitor 2DOF display crossed out for some cameras?
Please check if all the cameras used during room calibration are connected.
Please refer to the
sons of disconnected cameras.
Please refer to section 6.3.1 on page 45 for more information about Adding / remov-
ing cameras.
Why does the "(re-)calibration required" message appear in Monitor 2DOF?
Please make sure you have performed a correct room calibration using all con-
nected cameras.
Please refer to section 6.3.1 on page 45 for more information about Adding / remov-
ing cameras.
My target is not visualized within the Monitor 2DOF display.
Please make sure that the target is inside the tracking volume and within tracking
range of the cameras.
Double-check the settings for the flash intensities of the cameras (refer to chapter
8.3 on page 71).
In case you are using active targets, please make sure that you have activated the
modulated flash. Please refer to chapter 8.3 on page 71 for further details.
There are greyish areas in my Monitor 2DOF display. What do they indicate?
The static reflex suppression is currently active. This is indicated with these greyish ar-
eas. Markers in these areas will not contribute to tracking.
Please refer to chapter 6.3.2 on page 49 for more information.
What do the abbreviations "SR", "DR" and "UD" mean?
SR . . . static reflex suppression active
UD . . . display orientation is upside down
Please refer to chapter 6.3.1 on page 45 for more information on the additional
2DOF display settings.
ART Hardware Installation Guide
13.6 Software DTRACK3
FAQ for the common rea-
Monitor
173