Table of Contents
Advertisement
TIPS FOR CORRECT USE
To ensure optimal results from your air conditioner, follow these
recommendations:
•
close the windows and doors in the room to be air condi-
tioned. When installing the air conditioner semi-perma-
nently, you should leave a door slightly open (as little as 1
cm) to guarantee proper ventilation.
•
Never use the appliance in very damp rooms (laundries for
example).
•
Protect the room from direct exposure to the sun by par-
tially closing curtains and/or blinds to make the appliance
much more economical to run.
•
Never use the appliance outdoors.
•
Make sure there are no heat sources in the room.
•
Make sure the air conditioner is standing on a level surface.
do not cover the appliance
•
Never rest objects of any kind on the air conditioner.
•
Never obstruct the air intake or outlet flap.
CLEANING
Before cleaning or maintenance, turn the appliance off by
touching the
button, then unplug from the outlet.
CLEANING THE CABINET
You should clean the appliance with a slightly damp cloth then
dry with a dry cloth. For safety reasons, never wash the air con-
ditioner with water.
Attention! Never use petrol, alcohol or solvents to clean the ap-
pliance. Never spray insecticide liquids or similar.
CLEANING THE BIO SILVER AIR FILTER
The BioSilver filter helps capture dust and pollen and helps re-
duce the growth of bacteria and mold on the filter.
If the filter is dirty, air circulation is compromised and the effi-
ciency of the appliance decreases. It is therefore good practice
to clean the filter at regular intervals. The frequency depends
on the duration and conditions of operation. If the unit is used
constantly or systematically, you are recommended to clean the
filter once a week.
C5
C6
C7
C9
C12
C13
C11
C4
C1
The filter is housed in the intake grille.
To clean the filter, extract as shown in fig. 11.
Use a vacuum cleaner to remove the dust collected on the filter.
If it is very dirty, immerse in warm water and rinse a number of
times. The water should never be hotter than 40°C.
After washing the filter, allow it to dry completely before
repositioning it.
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and the
earth system is efficient.
Follow the installation instructions precisely.
END OF SEASON OPERATIONS
To drain all water from the circuit, remove the external cap by
unscrewing it in the anticlockwise (fig. 12) direction and allow
the water to drain out into a basin.
When the appliance is empty, replace the caps.
Clean the filter and dry thoroughly before putting back.
TECHNICAL SPECIFICATIONS
Power supply voltage
Max. absorbed power
during air conditioning
Refrigerant
Cooling capacity
Frequency
Maximum transmission power 0,0631 W
LIMIT CONDITIONS
Room temperature for air conditioning
Transport, filling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
TO AVOID DAMAGE TO THE UNIT:
Attention!
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will break down from lack of oil.
21
see rating label
"
"
"
2402.0-2483.5 MHz
18° ÷ 35°C
Advertisement
Table of Contents
