Panasonic DMP-BDT310 Operating Instructions Manual page 14

Search for wireless network:
≥ When you select "Search for wireless network", the
available wireless networks will be displayed. Select your
network name and press [OK].
– If your network name is not displayed search again by
pressing the red button on the remote control.
– Stealth SSID will not be displayed when you select
"Search for wireless network". Enter manually by using
"Manual setting".
(Press [HOME] select "Setup"
Settings" select "Network"
Settings" [OK] select "Wireless Settings"
select "Connection Setting"
setting" [OK])
≥ If your wireless network is encrypted, Encryption Key input
screen will be displayed.
Input the encryption key of your network.
An SSID (Service Set IDentification) is a name used by wireless LAN to
*1
identify a particular network. Transmission is possible if the SSID
matches for both devices.
Wi-Fi Protected Setup-compatible Wireless router may have the mark.
*2
When you experience
problems with settings
Wireless Settings
Wireless Settings
Failed to complete.
A conflict with another device occurred.
Do you wish to try wireless network connection
setting again ?
Yes
OK
Display
A conflict with other
devices occurred.
A time out error
occurred.
An authentication error
or a time out error
occurred.
A device error
occurred.
14
VQT3B75
select "Player
[OK] select "Network
[OK] select "Manual
No
Check the following
≥ Please wait a few moments,
and then try again.
≥ Setting of the Wireless router
for MAC Address etc.
≥ The signal may be weak.
[BDT110] : Using the USB
extension cable supplied with
the Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
≥ The SSID and the encryption
key of the Wireless router.
≥ Please wait a few moments,
and then try again.
≥ [BDT110] : Connection of
Wireless LAN Adaptor
≥ If there is no improvement in
symptom, consult your dealer.
Network Easy Setting (Home Network Connection
Check)
Network Easy Setting (Home Network Connection Check)
Complete.
1. LAN cable connection
2. IP address setting
3. Connection to gateway
LAN cable is not connected.
Please check the connection.
Select "Yes" and press [OK] to check network
connection again.
Select "No" and press [OK]
to finish Network Easy Setting.
Yes
[OK]
OK
1. LAN cable connection or
Wireless Settings
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Wireless Settings
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Wireless Settings
2. IP address setting
3. Connection to gateway
Network Easy Setting (Internet Connection Test)
Network Easy Setting (Internet Connection Test)
Complete.
- Connection to the Internet
Failed the connection test.
Cannot find the server.(B019)
Please refer to the operating instructions for the cause
of the error and the countermeasure for it.
Press [OK].
OK
Display
Cannot find the
server.
(B019)
Failed to connect to
the server.
(B020)
: Fail
: Fail
: Fail
No
Display
:Fail
:Fail
:Fail
:Pass
:Fail
:Fail
:Pass
:Pass or
Home
network
available
:Fail
: Fail(B019)
Check the following
≥ "Primary DNS" and "Secondary
DNS" settings of "IP Address /
DNS Settings" (
≥ The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥ Settings of "Proxy Server
Settings" ( 33) and the router
Check the
following
≥ Connection
of the LAN
cables
( 11)
≥ Connection
and settings
of the hub
and router
≥ Settings of
"IP Address /
DNS
Settings"
( 33)
33)