Sharp SD-AS10H(S) Service Manual page 12

SD-AS10H
11. Aging Mode 2 (Roller test)
During stand-by press DISC1+FUNCTION+POWER button.
Then press DISC2 button.
Button:
1) Normal: D1-D5, OPEN/CLOSE, PLAY, STOP, POWER
2) Aging: PLAY, STOP, POWER
Other button invalid.
All remocon button invalid.
Changer LED function as normal.
V/H sw function as normal.
MODE CAM, LOCK SW, UNLOAD SW, PLAY SW error detect function
as normal.
Start
Changer Initial Process
(Changer display)
D# + PLAY No
button
Yes
D# Play position
Mode 1 or 2
(Counter display)
Mode 4
Mode 7 or 8
Wait 1sec
Mode 4
Mode 1 or 2 Counter up
1. Start aging D1 if press PLAY button only.
2. If press D# + PLAY button, cam return to mode 1, then start aging
process for selected disc.
3. If press STOP button, aging process stop and all counter display as
last number.
4. If press POWER button, cancel test mode, then power off process.
5. If error occur, aging process stop, all counter display as last num-
ber and display error.
*Changer display same as page DI-7-1.
Can use D1-D5 and OP/CL button as normal.
*Counter display
AGING2 Test name.
ERROR CARRY
Error. Only if error occur.
D1 00000 Counter for disc 1.
D2 00000 Counter for disc 2.
D3 00000
Counter for disc 3.
D4 00000 Counter for disc 4.
D5 00000
Counter for disc 5.
(All character is in 5x7)
* "#" is disc number.
*Process continue unless
press STOP button.
*Default "00000".
After "99999" go to "00000".
12. Aging Mode 3 (Mode cam test)
During stand-by press DISC1+FUNCTION+POWER button.
Then press DISC3 button.
Button:
Normal aging
1) D1-D5, OPEN/CLOSE, PLAY, STOP, POWER
2) D1-D5, PLAY, STOP, POWER
Other button invalid.
All remocon button invalid.
Changer LED function as normal.
V/H sw function as normal.
MODE CAM, LOCK SW, LOAD SW, SHUTTER SW error detect func-
tion as normal.
Start
Changer Initial Process
(Changer display)
D# + PLAY No
button
Yes
D# LD/EJ position
Mode 1 or 2
(Counter display)
Mode 7 or 8
Mode 1 or 2
1. Start aging D1 if press PLAY button only.
2. If press D# + PLAY button, cam return to Mode 1, then start aging
process for selected disc.
3. If press STOP button, aging process stop and all counter display as
last number.
4. If press POWER button, cancel test mode, then power off process.
5. If error occur, aging process stop, all counter display as last num-
ber and display error.
2 – 5
*Can use D1-D5 and OP/CL button as normal.
*Counter display:
AGING2 Test name.
ERROR CARRY Error. Only if error occur.
D1 00000
Counter for disc 1.
D2 00000 Counter for disc 2.
D3 00000 Counter for disc 3.
D4 00000
Counter for disc 4.
D5 00000 Counter for disc 5.
(All character is in 5x7)
*Process continue unless
press STOP button.
Wait 1sec
Counter up
*Default "00000".
After "99999" go to "00000".