Cylinder Head - Honda CBR650RA Shop Manual

dummyhead dummyhead

CYLINDER HEAD

REMOVAL
Remove the following:
– Exhaust pipe/muffler (page 2-18)
– Throttle body (page 7-13)
– Camshaft (page 10-5)
Disconnect the ECT sensor 2P (Blue) connector [1] and
bleeding hose [2].
Remove the bolts [1] and water hose joint A [2] from the
cylinder head.
Remove the O-ring [3] from the water hose joint A.
Remove the 6 mm bolts [1].
Loosen the 9 mm washer-bolts [2] in a crisscross
pattern in 2 or 3 steps, then remove them.
Remove the cylinder head [3].
• Attach a piece of wire to the cam chain to prevent it
from falling into the crankcase.
• Do not tap the cylinder head too hard and do not
damage the mating surface with a screwdriver.
Remove the dowel pins [1] and gasket [2].
CYLINDER HEAD/VALVES
[1]
[3]
[1]
[1]
[1]
[2]
[2]
[2]
[3]
[2]
10-11