Changing The Bake Orifice - Thermador PAALTKITGW Installation Instructions Manual

4. Carefully lift the backguard assembly from the range.
Changing the broil burner orifice
1. Remove broil orifice using a 7/16'' box end wrench,
while restraining the elbow fitting from rotation using
a small adjustable wrench.
IMPORTANT: DO NOT bend the broil burner orifice
bracket. Ensure that the broiler orifice is aligned to the
center of the burner tube inlet.
2. Replace the orifices as indicated in the table.
12025444 — 48'' Pro Harmony and
36'' Pro Grand, LP units
Main oven broil
Auxiliary oven broil remain unchanged
PAALTKITH — 30'', 36, or 48'' Pro
Harmony
Main oven broil
Auxiliary oven broil remain unchanged
NOTE: The replacement broil orifices have straight
threads (not tapered threads) and DO NOT require thread
sealing compound.
3. Perform a gas leakage check of the orifice and
associated supply tube fittings, per "Gas leak
checking the broil orifice(s)" on page 14.

Changing the bake orifice

•
•
Removing the oven door
⚠
CAUTION
•
•
•
•
•
To gain access to the bake burner orifices, you will need to
remove the oven door, kick panel, and the bottom front
panel, if applicable.
To remove the oven door
1. Open the door fully. Flip the hinge clips down for both
No.
1.20 (120)
No.
2.00 (200)
2. Close the door gently until it stops against the hinge
PAALTKITH — for converting natural gas units above
5,400 ft. and up to 10,200 ft.
PAALTKITGW — for converting natural gas units
above 5,400 ft. and up to 10,200 ft. only
USE CAUTION WHEN REMOVING THE DOOR. THE
DOOR IS VERY HEAVY.
Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure to
do so could result in electrical shock or burns.
The oven door is heavy and fragile. Use both hands to
remove or replace the door.
Failure to grasp the oven door firmly and properly
could result in personal injury and product damage.
With the door off, never release the levers and try to
close the hinges. Without the weight of the door, the
powerful springs will snap the hinges closed with
great force.
sides of the door. A screwdriver may be required to
carefully pry the clip back.
clips. The open hinge clips will hold the door open at
a slight angle, about 30°, from the closed position.
11