Advertisement
STEP 3: Exit the vehicle and close the door. The vehicle's engine should shut off within upon closing the last door. If the vehicle's engine does not shut off,
your door trigger may be functioning improperly. Do not use the remote start feature and take your vehicle to a local authorized Firstech dealer for service.
IMPORTANT: By default, the system will lock/arm the vehicle upon setting reservation mode. Take to not lock your keys inside the vehicle.
Cancelling Reservation Mode
Reservation mode will be cancelled for the following reasons;
You did not activate the parking brake prior to turning off the ignition.
You pressed the foot brake after the key was removed from the ignition.
You released the parking brake after the key was removed from the ignition.
You entered valet mode, opened the vehicle's door, hood, or trunk.
Reservation Mode Settings
Reservation mode settings can be changed. It is recommended that reservation mode settings are programmed by your local authorized Firstech dealers.
Default 1: Locks doors when reservation mode is set.
Option 2: Does not lock doors when reservation mode is set.
Option 3: Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.
This option will allow you to access the vehicle's rear doors, trunk or hatch prior to the system setting reservation and passively locking/arming.
By Firstech, LLC
8
The optional Anti-Grind/Starter Kill feature prevents you from accidentally grinding your vehicle's starter motor when taking over with the key. This feature
requires additional installation and programming. Also your dealer can program a basic security feature that prevents your vehicle from starting when it is
locked/armed. Please see your dealer for more details.
The optional Secure Valet Switch prevents the remote start from being put into valet mode through cycling the ignition on/off five times. The Secure Valet Switch
is more secure than traditional toggle / valet switches because it requires a two digit code. Follow the below procedures to program your Secure Valet Passcode:
STEP 1: Turn on Option 3-10-III. (Dealer programmed option)
STEP 2: Turn ignition key to the <on> position.
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with successful completion of this step.
STEP 4: Enter the first digit of the desired two digit pass code by depressing the switch the number of times that coordinates with the desired first number. For
example, to enter 3, depress the switch 3 times, then wait.
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter your second number by repeating step 4.
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 - 5 to enter your Secure Valet code.
9
By Firstech, LLC
Advertisement
