Removing Blade - Panasonic EY45A2LJ2G Operating Instructions Manual

7. Hold the spindle lock button down. This pre-
vents the blade from rotating.
8. Tighten the hex bolt securely with the provid-
ed hex wrench. Store the hex wrench.
NOTE:
Keep the hex wrench in the storage slot on
the tool's body when not using it.
WARNING
Failure to follow these instructions can result in
serious personal injury.

Removing Blade

CAUTION:
The blade will be hot right after cutting. Be sure
to let the blade cool down before removing it.
Follow these steps:
1. Remove the battery pack from the tool.
Outer washer
Place the protrusion of the outer
washer into the position of the
washer.
Loosen
Tighten
Retracting handle
Hex bolt
Fig.4
- 15 -
2. Hold the spindle lock button down. This pre-
vents the blade from rotating.
3. Use the provided hex wrench to loosen the
hex bolt.
NOTE:
Keep the hex wrench in the storage slot on
the tool's body when not using it.
4. Remove the hex bolt and outer washer.
5. Use the retracting handle to retract (open)
the lower guard.
6. Carefully remove the blade.
7. Clean the tool if necessary.
CAUTION:
Be careful to avoid cutting your hands on the
blade.
• When disposing of a blade, secure it inside heavy
or corrugated paper. This will help prevent anyone
from being cut by the discarded blade.
Inner washer
Place the inner washer with cut-out
facing you.
Lower guard
Spindle lock button
EN