Table of Contents
Advertisement
user programmable channels to be scanned
for activity. Channels are scanned at a rate of
20 channels per second. If a busy channel is
found, scanning will pause to allow the signal to
be heard. Once the channel has been clear for
5 seconds, scanning will resume automatically.
Your TX3200 is supplied with all 40 UHF CB
channels programmed into the scan memory.
Any channels not required can be removed as
necessary.
1 - 2 - 3 - 4 - . . . . . . . . . . - 39 - 40
Programming Open Scan Memories.
To add or remove channels from the scan
memory:
1. Check that the radio is not already
scanning. If it is, briefly press the SCAN
key to cancel the scan function.
2. Select the required channel using the rotary
channel selector switch.
•
If "M" is displayed to the upper left of the
channel number, the selected channel is
presently in the scan memory. It can be
removed by holding the SCAN key in until a
low beep is heard. "M" will then disappear
indicating the channel is no longer in
memory.
•
If "M" is not visible to the upper left of the
channel number, then the selected channel
is not in the memory. To add it, hold the
SCAN key in until a high beep is heard.
"M" will now appear to the upper left of the
channel number.
3. Repeat step 2 to add or remove other
channels in the scan memory.
To scan the selected channels, briefly press the
SCAN key. A high beep will be heard, SCAN
will appear in the display and the radio will
begin scanning.
NOTE: If there are no channels programmed in
the scan memory when you press the SCAN
key, a low beep will be heard and the command
will be ignored.
If a busy channel is found, scanning will pause
on that channel to allow the signal to be heard
and will remain there for as long as the channel
remains busy. Once the channel has been
clear for 5 seconds, scanning will resume
automatically.
•
To skip over a busy channel, briefly press
the SCAN key twice.
•
To talk on a busy channel while in Scan
mode simply press the Push-To-Talk button
on the microphone. The radio will exit the
Scan mode and remain on the channel.
When you have finished your conversation,
briefly press the SCAN key to resume
scanning.
To cancel the Scan, briefly press the SCAN
•
key. A low beep will be heard and "SCAN"
will disappear from the display. The radio
will remain on the last channel that was
scanned.
NOTE: The radio will not scan if the squelch is
open.
OPTIONAL GROUP SCAN FUNCTION
"Group Scan" is a dealer activated alternative
to the standard "Open Scan" function
described above. It is intended for situations
where the user needs to operate on their
regular working channel but also wants to
monitor several other channels. If you believe
that the group scan feature is more useful to
your needs, contact your dealer to arrange for
your TX3200 to be reprogrammed.
With Group Scan installed, you can transmit
and
receive
normally
(working) channel, but between breaks in the
conversation, the radio will scan and listen
to several other channels. The receiver will
continue to scan the other channels ONLY
WHILE THERE ARE NO SIGNALS ON THE
PRIORITY CHANNEL.
e.g. Using priority channel 20 with GS channels
1, 2, 3, 4, 5 and 6.
5
on
your
priority
Advertisement
Table of Contents
