Table of Contents
Advertisement
Available languages
Available languages
EN
11.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.
11.3 CRUISE CONTROL LEVER
1. Pull the cruise control lever (2) clockwise to increase
the speed. This will lock the speed at the desired
setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
If you decrease the speed all the way, the unit will stop
and it is necessary to start the machine again.
11.4 TURBO BUTTON
1. Push the turbo button (1), the machine is at the
highest speed.
2. Release the turbo button, the machine is at the
normal speed.
Using the turbo button drains the battery the fastest.
Only use the turbo button when needed.
11.5 OPERATION TIPS
•
Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
•
Use rakes and brooms to clear the unwanted
material before you blow.
•
Make the surfaces wet before you clear the
unwanted material in dusty conditions.
•
Look out for children, pets, open windows, and
cleaned cars during operation.
•
Clean the machine.
NOTE
1
2
3
NOTE
NOTE
English
•
Discard the unwanted material when you complete
work.
12
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
12.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
•
Clear the unwanted material out of the air vent with
a vacuum cleaner.
•
Do not spray the air vent or put the air vent in
solvents.
•
Clean the housing and the plastic components with
a moist and soft cloth.
13
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
transportation and storage.
13.1 MOVE THE MACHINE
•
Only hold the machine with the handgrip.
13.2 STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure that the motor is not hot when you store
the machine.
•
Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service
center.
10
CAUTION
CAUTION
WARNING
CAUTION
WARNING
Advertisement
Chapters
Table of Contents
