JVC GR-FXM55 Instructions Manual page 39

Basic Connections
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2
CONNECT CAMCORDER TO TV OR
VCR
Pull out the connector cover and open it.
Connect as shown in the illustration (
If using a VCR . . . go to step 3.
If not . . . go to step 4.
3
CONNECT VCR OUTPUT TO TV
INPUT
Refer to your VCR's instruction manual.
4
SUPPLY POWER
Turn on the camcorder, the VCR and the TV.
5
SELECT MODE
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
NOTES:
● It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack ( pg. 5).
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power Switch to "CAMERA" ("AUTO"
or "PRO."), then set your TV to the appropriate
input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
● If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
Downloaded from: https://www.usersmanualguide.com/
Tape Dubbing
1
CONNECT EQUIPMENT
Following the illustration on pg. 38, connect the
camcorder and the VCR.
2
PREPARE FOR DUBBING
Set the camcorder's Power Switch to "PLAY",
turn on the VCR's power, and insert the
pg. 38).
appropriate cassettes in the camcorder and the
VCR.
3
SELECT VCR MODE
Engage the VCR's AUX and Record-Pause
modes.
4
FIND EDIT-IN POINT
Engage the camcorder's Play mode to find a spot
just before the edit-in point. Once it is reached,
press PLAY/PAUSE (4/6) on the camcorder.
5
START EDITING
Press PLAY/PAUSE (4/6) on the camcorder and
engage the VCR's Record mode.
6
STOP EDITING TEMPORARILY
Engage the VCR's Record-Pause mode and press
PLAY/PAUSE (4/6) on the camcorder.
7
EDIT MORE SEGMENTS
Repeat steps 4 through 6 for additional editing,
then stop the VCR and camcorder when
finished.
39
EN