Table of Contents
Advertisement
Instruments and indicators
EMU26622
Trim meter
This meter shows the trim angle of your out-
board motor.
Memorize the trim angles that work best for
your boat under different conditions. Ad-
just the trim angle to the desired using the
power trim and tilt switch.
If the trim angle of your motor exceeds the
trim operating range, the top segment on
the trim meter display will blink.
EMU26652
Hour meter
This meter shows the number of hours the
engine has been run. It can be set to show the
total number of hours or the number of hours
for the current trip. The display can also be
turned on and off.
To change the display format, press the
"
" (mode) button. The display can show
total hours or trip hours, or turn off.
33
To reset the trip hours, simultaneously press
the "
more than 1 second while the trip hours are
displayed. This resets the trip counter to 0
(zero).
The total number of hours the engine has
been run cannot be reset.
EMU26525
Low oil pressure-alert indicator
If oil pressure drops too low, the alert indica-
tor will start to blink. For further information,
see page 46.
ECM00023
NOTICE
Do not continue to run the engine if the
low oil pressure-alert indicator is on and
the engine oil level is lower. Serious en-
gine damage will occur.
The low oil pressure-alert indicator does
not indicate the engine oil level. Use the
ZMU01740
oil dipstick to check the remaining oil
quantity. For further information, see
page 53.
1. Low oil pressure-alert indicator
EMU26584
Overheat-alert indicator
If the engine temperature rises too high, the
ZMU01741
alert indicator will start to blink. For further in-
formation on reading the indicator, see page
46.
" (set) and "
" (mode) buttons for
1
ZMU01736
Advertisement
Table of Contents
