Table of Contents
Advertisement
• A 50-foot clearance in all directions is best.
• Push down firmly on the center of the cups to reseat them.
• Cups are replaceable.
Occasionally, a bad storm with hail or debris that will damage your wind cups. These are
easily replaced.
Replace wind cups:
1. Loosen the screw on side of cups
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit on the flat side of the metal stem on the sensor.
WIND READING 0.00: WHY DO I ONLY SEE 0.00 FOR WIND SPEED?
The 0.00 means your wind sensor is connected to your station.
• Check that the cups spin freely. Something may be preventing movement.
• Are your wind cups unbroken? After a storm it is good to check this.
WIND DASHES: WHY ARE THERE DASHES FOR WIND READINGS?
Dashes indicate the connection is lost between your station and the wind sensor.
• My first thought is always to check that my
now is not, low batteries are the most common connection problem.
• Next, check your
previously at the same location, this is likely not the issue. However sometimes there is
new growth on trees or bushes that causes another barrier. Radio Frequency (RF) signal
does not travel well through foliage due to the moisture content.
• Occasionally adding a new wireless electronic device to the home will cross the signal
path for the sensor. If this occurs try moving your station a few feet or turning the
station 90 degrees for a better angle to receive the sensor signal.
• When you have good batteries, and in a good location, hold the SENSOR button for three
seconds to search for your sensors. If you regain connection while the sensor is
mounted, great. If you do not regain connection, bring the sensor within 10 feet of the
station and search again.
CAN I REPLACE MY WIND CUPS?
distance, resistance and
batteries
are good. If it has been working and
interference. If everything was working
17 |
P a g e
Advertisement
Table of Contents
