Table of Contents
Advertisement
wall using the screws provided, then fit the drainage tube into the
30mm hole and seal with foam as above.
If the outside of the wall is not accessible, proceed as follows.
Attach the nylon cords to the rubber ring as shown.
Fold the rubber ring in half and pass it through the
hole, keeping hold of the other ends of the nylon
cords.
Slide the tube (with the inside flange attached) into the hole,
passing the nylon cords through the tube. Seal the area
between the tube and the hole with expanding
polyurethane foam, and then push the tube completely
into the hole.
Attach the cords to the tabs on the interior flange and pull tight.
Attach the hanging bracket to the fixing holes, using the screws
provided.
Stick the foam gaskets to the back of the unit, around the air intake
With two people, lifting the appliance by it sides, not the front
NOT HERE
LIFT
HERE
engage properly with the drain tube in the wall, leakage will occur.
and exhaust ports.
Connect the drain hose provided to the rear
drain outlet. A further extension pipe with an
internal diameter of 16mm can be fitted if
required. Care must be taken to ensure that
the drain always runs downwards.
cover, hang it on the fixing bracket, and
LIFT
push firmly against the wall, ensuring
HERE
that the drain pipe engages with the
drainage hole, and that the main unit fits
flush against the wall. If there are any
gaps between the unit and the wall,
heating and cooling performance will be
impaired.If the drain pipe does not
Page 4
Advertisement
Table of Contents
