Troubleshooting; Flash Codes For The Digital Display Controller - Echo BEAR CAT CH6720H Owner's Manual

6

TROUBLESHOOTING

Section

6.1 FLASH CODES FOR THE DIGITAL DISPLAY CONTROLLER

FREQUENCY
GREEN
Chipper has reached required RPM
Solid
and forward feed is available
1/2 second on, Chipper has not reached chipping RPM
1/2 second off upon initial startup
1/2 second on,
Chipper RPM dropped while chipping
1/2 second off
RED
Solid Knee bar was activated
Solid Battery voltage is low
YELLOW
Controller has detected an electrical
Solid
system fault
26
CAUSE
6 INCH CHIPPER
ACTION TO TAKE
Machine ready for chipping
Slowly increase RPM
Feed roller will automatically reverse to bring RPM
back up
Hold Knee Bar Reset
Charge battery. Check charging system.
Use diagnostics screen information on controller or
see troubleshooting section in manual