Adjusting The "Ready In" Time Before The Programme Starts; Adding Laundry; Cancelling The Programme; Resuming The Programme When The Programme Status Is Rinse Hold - Bosch WAU28US8SN User Manual And Installation Instructions

a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
Press .
1.
Press repeatedly until the dis-
2.
play indicates the desired "Ready
in" time.
Press .
3.

Adding laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press .
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
Add or remove laundry.
2.
Close the door.
3.
Press .
4.

Cancelling the programme

Once the programme has started,
you can cancel it at any time.
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press .
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Sköljning programme.
– If the water level is high: Start
the Centrifugering or Urpumpn-
ing programme.
Remove the laundry.
3.
Resuming the programme
when the programme status
is Rinse Hold
Set the Centrifugering or Ur-
1.
pumpning programme.
Press .
2.

Unloading the laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Open the door.
1.
Remove the laundry.
2.
Basic operation en
35