Installation Notes - PSB CustomSound CW180R Specifications

CW180R / CW180S 8" Coaxial Speaker System
• Platinum-derived 8" woofer and 1" tweeter
• Unique high-frequency, constant directivity SonicGuide™
gimbals to provide a focused, even response both on
and off axis
• SonicGuide™ can be tilted 30° left or right and the whole
assembly turned through 90 degrees
• Fully enclosed back box NCB available
• Midrange and tweeter switches allow for response
adjustments
11.125"
283mm
11.125"
283mm
PSB Speakers reserves the right to change specifications or features without notice.
© 2004 PSB Speakers, a division of Lenbrook Industries Limited.
PSB is a registered trademark of Lenbrook Industries Limited. Printed in Canada 10/04. All rights reserved.
No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers.
Frequency Range (-6dB):
Recommended Power:
Impedance:
Sensitivity (1W (2.83V) @1m)
Drivers:
Overall Dimensions (W x D):
Cut-out Dimensions (W):
Overall Dimensions (W x H x D):
Cut-out Dimensions (W x H):

Installation Notes

• Optimum installation height (CW180S) is
9.875"
251mm
• Distance between left and right speakers
• Make small exploratory hole and check for
4"
102mm
• Mounting template provided.
• Lightly fi ll wall cavity with fi berglass 2 feet
9.875"
251mm
• Adjust electric screwdrivers to appropriate
• SonicGuide tweeter can be turned +- 45
4"
102mm
• Aim tweeter toward center of listening area
• Switches give subtle balance adjustments
• See manual for more installation hints.
To Reach US Customer Ser vice dial 1 888 772 0000 ext 4445 or 4342
38-21,000Hz
20-100 Watts
8 Ohms
Anechoic Chamber: 88dB SPL
Typical Listening Room: 90dB SPL
8" Woofer
1" Dome Tweeter
11 1/8 diameter x 4"
9 7/8" diameter
11 1/8 x 11 1/8 x 4"
9 7/8 x 9 7/8"
between seated and standing ear level
position.
(CW180S/R) should approximately equal the
distance from the listening area to the wall or
ceiling.
obstructions in wall cavity before cutting
mounting hole.
above and below system (CW180S). Use
standard 4" fi berglass split to half thickness.
Use 1" thick fi berglass behind system.
torque. Tighten 4 mounting screws fi rmly but
do not over tighten!
degrees via the gimbal ring, then +- 30
degrees on its axis (see illustration on left).
via SonicGuide and gimbal ring.
for midrange and treble. Set to suit room
acoustics and personal taste.
w w w. p s b s p e a k e r s . c o m
1 8 8 8 7 7 2 0 0 0 0