Table of Contents
Advertisement
General Programming Instructions
Default Setting
Required Telephone Set
Extensions Used for
Programming
To Check the
Programmed Data
Before Programming
After Programming
18
This system has a default factory setting. If any of the program-
ming needs to be changed, you can change the setting by system
programming.
You can use any of the following telephones for system program-
ming:
• Proprietary Telephone (PT): KX-T7130, KX-T7030, KX-T7020,
• Single Line Telephone (SLT): tone type
All telephones (except KX-T7130 and KX-T7030) do not have
display panels, so you cannot check the setting you have made.
Therefore, please use KX-T7130 or KX-T7030 to check the
programming.
System programming can only be performed from extension 21.
Use KX-T7130 or KX-T7030. When you check the assignment,
set the MEMORY switch on PT to "PROGRAM".
Enter "#" and the program address.
You cannot check programs #60, #62, #63, #65, #66 and #69, as
they are not displayed on the display panel.
To enter the system programming mode:
[Off-hook]
To exit the system programming mode:
[Off-hook]
KX-T7050, KX-T7055
6
2
0
6
2
0
6
6
2
0
6
Advertisement
Table of Contents
