Installing The Stand - Dell Inspiron 24 5421 Owner's Manual

Steps
1. Locate the tab on the stand, and push a scribe into the tab to release the stand from the display-assembly base.
2. Lift the stand off the display-assembly base.

Installing the stand

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and
you must replace both of these components together. Refer to the procedure for
the stand hinges.
About this task
The following image indicates the location of the stand and provides a visual representation of the installation procedure.
46 Removing and installing Customer Replaceable Units (CRUs)
removing the stand hinges and installing