Bucket Types And Applications; Specifications - Hitachi ZAXIS 210LC-5N Operator's Manual

Bucket Types and Applications

ZX210LC-5N
IMPORTANT:
 When digging on a solid ground with the super
long front attachment, the front attachment may be
damaged.
 Use the super long front attachment for digging of
soft ground. Install the standard front attachment
for general excavation work.
 If a wide-size bucket other than the above is used for
operation, it may result in a front attachment twist
and damage to the parts.
 Ensure the total weight of the bucket and material
load does not exceed the maximum allowable
loading weight of the machine when operating the
machine.
The maximum allowable weight is determined by
Hitachi standards. If the total load exceeds this value,
it may cause machine turnover or damage on the
front attachment. Select a bucket having capacity
and weight with maximum allowable loading weight.
Use a bucket in combination shown in the below table
when the super long front attachment is installed. If a mass
excavation bucket or an extreme service excavation bucket
which is not described in the table is used, the machine
stability will not be secured and the strong force may be
applied to the main body, front attachment and cylinders,
resulting in damage on the machine.
Use the bucket and the arm in combination only as described
in the below table.
Bucket
Hoe Bucket
Slope-Finishing Blade
Max. weight kg(lb)
* Standard Bucket
: For light duty excavating (digging and loading operation of wet, loosened earth, sand, mud and so on, the bulk

density shall be less than 1800 kg/m
: Slope-finishing work


SPECIFICATIONS

Bucket Capacity
(m )
3
Heaped
0.45
–
3 as a standard.)
Bucket Width
mm (ft·in)
CECE Without side cutter
0.40 850 (34")
– 1500 (4'11")
7-4
Model
ZX210LC-5N
H15
*

1130 (2490)