Samsung NK30CB700W Series Installation Manual page 13

Connect Filter Support Cable
MANUAL INSTALL_Range Hood_DG68-01500A.indb 13 MANUAL INSTALL_Range Hood_DG68-01500A.indb 13
1. Remove the filter at the bottom of
the hood. Pass the filter support cable
through the wire loop attached on
the top of the filter. Make the knot by
passing hook of filter support cable
through the other end of the filter
support cable.
2. Hang the hook of the filter support
cable to anchor at bottom of the
hood. Assemble the filter.
Installing the Recirculation Kit
NOTE
Same process until No. 14
Duct Cover Mounting Bracket
Deflector
Assembly
screws
A
B
C
D
1. Assemble the air deflector with the
duct cover mounting bracket with the
four assembly screws provided with
the Recirculation Kit.
NOTE
• Use of recirculation type hoods
in closed spaces may cause poor
ventilation performance.
• Please ventilate the room by opening
the windows while operating the
device.
2. Measure from the bottom of the deflector
to the bottom of the hood outlet.
3. Cut the duct to the measured size "X."
4. Remove the deflector.
5. Slide the duct onto the bottom of the
deflector.
6. Place the assembled deflector and duct
over the exhaust outlet from the hood.
7. Reassemble the air deflector to the duct
cover mounting bracket with the four
assembly screws.
8. Seal the connections with tape.
A Deflector
X = length to cut
B
duct
C Duct
D Exhaust outlet
English 13
2023-01-05 오후 3:15:33 2023-01-05 오후 3:15:33