Table of Contents
Advertisement
Siemens AG
Safety Guidelines
This manual contains notices you have to observe in order to ensure your personal safety, as well
as to prevent damage to property. The notices referring to your personal safety are highlighted in
the manual by a safety alert symbol, notices referring only to property damage have no safety alert
symbol. These notices shown below are graded according to the degree of danger.
Danger
indicates that death or severe personal injury will result if proper precautions are not taken.
Warning
indicates that death or severe personal injury may result if proper precautions are not taken.
Caution
with a safety alert symbol, indicates that minor personal injury can result if proper precautions are not taken.
Caution
without a safety alert symbol, indicates that property damage can result if proper precautions are not taken.
Notice
indicates that an unintended result or situation can occur if the corresponding information is not taken into
account.
If more than one degree of danger is present, the warning notice representing the highest degree of
danger will be used. A notice warning of injury to persons with a safety alert symbol may also in-
clude a warning relating to property damage.
Qualified Personnel
The device/system may only be set up and used in conjunction with this documentation. Commis-
sioning and operation of a device/system may only be performed by qualified personnel. Within the
context of the safety notes in this documentation qualified persons are defined as persons who are
authorized to commission, ground and label devices, systems and circuits in accordance with es-
tablished safety practices and standards.
Prescribed Usage
Note the following:
Warning
This device may only be used for the applications described in the catalog or the technical description and
only in connection with devices or components from other manufacturers which have been approved or
recommended by Siemens. Correct, reliable operation of the product requires proper transport, storage,
positioning and assembly as well as careful operation and maintenance.
Trademarks
All names identified by ® are registered trademarks of the Siemens AG. The remaining trademarks
in this publication may be trademarks whose use by third parties for their own purposes could vio-
late the rights of the owner.
Disclaimer of liability
While we have verified the contents of this manual for agreement with the hardware and software
described, variations remain possible. Thus we cannot guarantee full agreement. The contents of
this manual are regularly reviewed and corrections are included in subsequent editions. We wel-
come all suggestions for improvement.
Copyright © SIEMENS AG 2005
Subject to change without further notice
SIL Safety Manual ULTRAMAT 6 Gas analyzers
A5E00729183-02
2 of 19
Advertisement
Table of Contents
