Craftsman T100 Series Instruction Manual page 10

4. Then with the previously removed shoulder bolts (a) and flange lock nuts
(b) secure one side of the seat and seat bracket. While supporting the seat,
remove the Phillips screwdriver and secure the other side of the seat. Be
careful not to crimp or damage the wire harness while installing the seat.
See Figure 3.
(a)
5. Using the harness clip attached to the harness, secure the excess wire to the
fender by snapping the harness clip in place as shown in Figure 4.
(b)
(b)
(a)
Figure 3
Figure 4
ASSEMBLY
Lower Deck Discharge Chute Deflector
Never operate the mower deck without the chute deflector installed and in
the down position.
1. Check the mower deck for a shipping brace that may be holding the chute
deflector upward for shipment. If the brace is present, it must be removed
before operating the tractor. Holding the chute deflector fully upward,
remove the shipping brace. Lower the chute deflector and discard the
shipping brace. See Figure 5.
Installing the Hood Collar (If necessary)
There are three (3) alignment posts (a) on the hood collar (b) that line up with
corresponding alignment holes (c) in the hood (d). See Figure 6.
10
WARNING
Figure 5
(c)
(b)
(d)
(a)
(c)
(c)
Figure 6
(a)
(a)
(a)