Dell Latitude D610 Service Manual page 11

Installing the Microprocessor Module
NOTICE:
the ZIF socket does not require force.
NOTICE:
ZIF socket.
1. Align the pin-1 corner of the microprocessor module with the pin-1 corner of the ZIF socket, and insert the microprocessor module.
NOTE: The pin-1 corner of the microprocessor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
NOTICE:
When the microprocessor module is correctly seated, all four corners are aligned at the same height. If one or more corners of the module are higher
than the others, the module is not seated correctly.
2. Tighten the ZIF socket by turning the cam screw clockwise until you cannot turn the screw any further to secure the microprocessor module to the
system board.
3. Replace the other computer parts you removed earlier in this procedure.
4. Update the BIOS using a flash BIOS update program CD. For instructions on how to flash the BIOS, see
Back to Contents Page
Great user manuals database on
Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module properly in
A microprocessor module that is not properly seated can result in an intermittent connection or permanent damage to the microprocessor and
You must position the microprocessor module correctly in the ZIF socket to avoid permanent damage to the module and the socket.
UserManuals.info
"Flashing the BIOS."