Optoma PK301 User Manual page 4

C B
hargIng the attery
1
2
4
vga/c
c
omponet
onnect
1
2
1
2
1
2
1
2
4
1. Remove protection cap and insert
the plug. (  )
2. Connect the charger. (  ~  )
3. During charging the LED indicator
lights red. (  )
Projector will not charge while
operating.
4. The LED Charge Indicator will turn
green when battery is fully charged.
This process may take up to3 hours
3
<Note>
1. For more LED indicator, see page 7.
2. Before using the first time, charge until
battery indicator turns green.
3. After the projector is turned off, the battery
may not start charging right away due to the
high temperature emitted by the projector.
s - (vga/uSB/hDmI/c
ource
CONNECT INPUT SOURCE
1. Connect the VGA/Component
source device with the Universal I/O
connector.
Insert universal connector with
arrow mark facing up.
2. After powering on the projector,
or
press "Auto Search Source
Button" to change sources.
<Note>
1. USB device: Support USB Flash Drive
up to 5V/150mA, but does not support USB
Hard Disk Drive
2. Female USB cable, Component cable,
and HDMI cable are optional accessories.
or
CONNECT HDMI SOURCE
1. Connect the HDMI source device
to the mini HDMI conne connector.
(  ~  )
2. After powering on the projector,
press "Auto Search Source
Button" to change sources.
or
CONNECT USB SOURCE
1. Connect the USB flash drive to the
micro USB port using the female
USB cable. (  ~  )
2. Select USB Flash Drive from
the Main Menu.
c
onnect
vga/c
c
)
omponent In
onnect
I m
nSert Icro
vga/c s
omponet ource
1. Connect the AV input source.
(  ~  )
2. After powering on the projector,
press
Button" to change sources.
1
3. Connect earphones or amplified
external speakers to the audio out
connector of the projector (  )
2
or
<Note>
1. All other brand and product names are
trademarks or registered trademarks of their
1
respective companies.
2. The connecting cable of video output
device is not supplied, please contact their
service center.
3. iPod nano/iPod touch/iPhone/iPod classic
(version 5 and above)
4. Designed for iPod/iPhone/Mobile phone/
PMP with TV out functions. Using with
2
device with audio signal voltage > 0.3Vrms
is not recommended.
or
1
2
s
omponet
ource
1. Connect laptop or PC for data
transfer to the Projector internal
memory or additional MicroSD
1 memory using the supplied Male
USB Cable. When connected,
switch the Projector on.
MOLEX
2
<Note> The laptop/PC can only detect the
input source when the Projector is switched on.
The projection will stop when this connection is
made.
SD c
arD
1. Insert a MicroSD card into the
slot with the gold contacts facing
down.
2. Select
the Main Menu.
<Note> MicroSD card is optional.
- (v )
IDeo In
"Auto Search Source
or
3
D
ata tranSfer
MicroSD Card from