Warning: Lamp
compartment is hot!
Allow it to cool down
before changing
lamp!
Warning: To
reduce the risk of
personal injury, do
not drop the lamp
module or touch the
lamp bulb. The bulb
may shatter and cause
injury if it is dropped.
English
40
Replacing the lamp
The projector automatically detects the lamp life. When
the lamp life is nearing the end of use, you will receive a
warning message.
When you see this message, please contact your local
reseller or service center to change the lamp as soon as
possible. Make sure the projector has been cooled down
for at least 30 minutes before changing the lamp.
1
2
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the Power
button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the 2 screws from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and do "Lamp Reset" after the lamp
module is replaced.
Lamp Reset: (i)Press "Menu" (ii)Select "Options" (iii)Select
"Lamp settings" (iv)Select "Lamp reset (v)Select "Yes".
Appendices
3
4