Removing The Front Wheel (For Yp250R); Removing The Front Wheel (For Yp250Ra); Disassembling The Front Wheel; Checking The Front Wheel - Yamaha MBK XMAX 2014 Service Manual

EAS2DM1001
REMOVING THE FRONT WHEEL (for
YP250R)
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Front brake caliper
ECA2DM1001
NOTICE
Do not operate the brake lever when remov-
ing the brake caliper.
3. Elevate:
• Front wheel
TIP
Place the vehicle on a suitable stand so that the
front wheel is elevated.
EAS2DM1002
REMOVING THE FRONT WHEEL (for
YP250RA)
ECA2DM1002
NOTICE
• Keep any type of magnets (including mag-
netic pick-up tools, magnetic screwdrivers,
etc.) away from the front wheel sensor or
front wheel sensor rotor; otherwise, the
sensor or rotor may be damaged, resulting
in improper performance of the ABS sys-
tem.
• Do not drop the front wheel sensor rotor or
subject it to shocks.
• If any solvent gets on the front wheel sen-
sor rotor, wipe it off immediately.
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Front brake caliper
ECA2DM1003
NOTICE
• Be sure not to contact the sensor electrode
to any metal part when removing the front
wheel sensor from the outer tube.
• Do not apply the brake lever when remov-
ing the brake caliper.
3. Elevate:
• Front wheel
TIP
Place the vehicle on a suitable stand so that the
front wheel is elevated.
EAS21910

DISASSEMBLING THE FRONT WHEEL

1. Remove:
• Oil seal
• Wheel bearings
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼
a. Clean the surface of the front wheel hub.
b. Remove the oil seal "1" with a flat-head
screwdriver.
TIP
To prevent damaging the wheel, place a rag "2"
between the screwdriver and the wheel surface.
c. Remove the wheel bearings "3" with a gener-
al bearing puller.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲
EAS21920

CHECKING THE FRONT WHEEL

1. Check:
• Wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
EWA13460
WARNING
Do not attempt to straighten a bent wheel ax-
le.
4-20
FRONT WHEEL
▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼▼▼
▲ ▲▲▲ ▲ ▲▲▲