Hisense AVT52UR4RA4 Use And Installation Instructions page 19

(2) • Place the left hanger bracket on the nuts and
washers of the suspension bolts.
• Make sure that the left hanger bracket is fixed on
the nuts and washers securely, install the right
hanger bracket suspension hook on the nuts and
washers.
(When installing the indoor unit, you can slightly
remove the suspension bolts.)
(3) Fix with 4 suspension bolts, which can
endure load of 530N.
(4) Check the measurements of the length of
the suspension bolts.
(5) Fasten the hanging plate onto the
suspension bolts.
(6) Install the unit to the hanging plate.
I. Slide the unit from front side to hang on the
hanging plate with bolts.
ii. Fasten the four fixing bolts (M8:2 each on
the left and right sides) firmly.
iii. Fasten the two screws (M5:1 each on the
left and right sides).
Hanging plate
Fig. 3.3.9
Ceiling
Hanging plate
Suspension bolt
Fig. 3.3.8
Hanging plate
fixing bolts(M8)
Hanging plate
screw (M5)
Installation and Maintenance
Floor standing type installation
(1) Select the suspension bolt locations and the pipe
hole location.
I. Use enclosed paper pattern as a reference, and
drill the holes for the suspension bolts and pipe.
Note:
Decide the locations based on the direct
measurements.
ii. After the locations are properly placed, the paper
pattern can be removed.
(2) Install the suspension bolts in place.
Wall
Floor
Fig. 3.3.10
3) Fix with 4 suspension bolts, and fasten the four fixing
(
bolts (M8:2 each on the left and right sides) firmly.
(4) Fasten the two screws of Air Intake Grille
(M5:1 each on the left and right sides).
3.3.5 The horizontal adjustment of the indoor unit
(1) Make sure that the hanger bracket is fixed by the nut
and the washer.
(2) Adjust the height of the unit.
(3) Check if the unit is positioned horizontally.
*To ensure smooth drain flow, install the unit with a
descending slope (0-3mm) towards the drain outlet.
(4) After the adjustment, tighten the nut and smear the
thread locker on the suspension to prevent the nuts
from loosening.
CAUTION
During the installation, please cover the unit with the
plastic cloth to keep it clean.
17
Pattern board