Connecting Antennas - Onkyo HT-R410 Instruction Manual

Connecting antennas

Connecting the supplied FM and AM indoor antennas
1 Strip away the insulation from
the end of the cord.
2 Fully insert the stripped end of
the cord.
Adjusting the position of the FM indoor antenna
The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is
received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.
Rotate the outer frame
of the antenna.
Press and hold up
the lever.
Note
Insert one end of the AM antenna cord to either of the AM antenna connectors and the other end to the other connector. There is no difference
between one end of the AM antenna cord and the other end, unlike the speaker cables which have positive and negative poles.
Adjusting the position of the AM indoor antenna
The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as
possible from the HT-R410, televisions, speaker cables, and power cords.
When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.
14
ANTENNA
FM
AM
75 ANTENNA
VIDEO 3 VIDEO 2 VIDEO 1 DVD
IN OUT IN
DIGITAL INPUT
OPTICAL COAXIAL REMOTE
CONTROL
IN IN OUT IN
IN OUT IN IN IN OUT IN FRONT
L
SUBWOOFER
PRE OUT
R
CD TAPE VIDEO 3 VIDEO 2 VIDEO 1
Insert into the
hole.
Insert the end of the
cord.
FRONT FRONT
SPEAKERS B SPEAKERS A
MONITOR
R L R
OUT
IN
S VIDEO
IN
VIDEO
SURR CENTER
L
R
SUB
WOOFER
DVD
Extend the
antenna cord.
Release the lever to
secure the connection.
CENTER SURROUND
SPEAKER SPEAKERS
AC OUTLET
L R L
AM
AM indoor antenna
AM
FM indoor
antenna
FM
ANTENNA
75
FM
75 ANTENNA