Sunbeam 9362 Owner's Manual page 16

Operation
Caution: Do not attempt to operate until you have read and understand all Safety Information in this manual and all
assembly is complete and leak checks have been performed.
Before Turning Gas Supply On:
enclosed area.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is replaced
and fastened prior to starting.
Before Lighting:
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak
manufacturer. The burner must be replaced prior to the appliance being put into operation if it is evident that the burner
Lighting:
1. Make sure the control knob is in the "OFF" position (Figure A).
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge air from gas lines
before proceeding.
(you should hear a clicking sound).
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should pass before
attempting to light.
LOW
IGNITOR
Figure A
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this
than 10 seconds before igniting the gas will cause
WARNING
FOR YOUR SAFETY
Fire table will be hot after use. Handle with
extreme care.
Page 16
OFF
IGNITOR
HIGH
OFF
LOW
HIGH
Figure B
Re-lighting:
1. Turn control knob to "OFF".
2. Repeat the "Lighting" steps on prior page.
Turn off:
1. To extinguish burner depress control knob and continue
to turn it clockwise to "OFF".
2. Turn cylinder valve clockwise to "OFF" and disconnect
OFF
LOW
IGNITOR
HIGH
Figure C