Table of Contents
Advertisement
2.
Remove the four screws securing the drive to the drive bay.
There are two screws on each side of the drive.
3.
Slide the drive out the back of the bay.
4.
If you removed the only IDE device connected to the interface
the device used, you may want to disconnect the device
cable from the interface on the main system board and
remove it from the computer.
5.
If you have finished installing or removing drives, replace
the computer's cover, as described under "Replacing the
Cover" in Chapter 4. Then see "Using the Fixed Disk Setup
Option" in Chapter 2 for instructions on defining your new
drive configuration.
6-10
Installing and Removing Tower Drives
Advertisement
Table of Contents
