Epson ActionPC 2000 User Manual page 23

4. To turn on the computer, press the power button located on
the right side of the front panel, as shown below.
speed light
The power indicator lights up. After a few seconds, the
computer displays a count of its system memory, and then
performs its power-on diagnostics. This is a series of checks
the computer runs each time you turn it on to make sure
everything is working correctly.
5. If necessary, use the controls on your monitor to adjust the
brightness and contrast until you can easily see the
characters on the screen.
6. When the system has successfully completed its diagnostics,
MS-DOS
If they are correct, press
date and time.
Setting Up Your System
1-8
power light
diskette drive
®
prompts you to verify the correct date and time.
hard disk or
hard disk
diskette
access light
drive bay
I
Enter.
Otherwise, enter the current
reset
button
power
button