Operation; Using The Holster - Makita UP100D Instruction Manual

NOTICE:
Tighten the bolts with the hex wrench
in the upright position as shown in the figure.
Tightening the bolts too much may damage the bolts.
1
Fig.16
► 1 . Hex wrench
After installing the shear blades, check the clearance
of shear blades by confirming the following points. If
the clearance is not proper, adjust it by referring to the
section for adjustment for shear blades clearance.
• Check that there is no gap between the upper
shear blade and lower shear blade.
Fig.17
• Check that the upper shear blade moves approxi-
mately 3 mm toward the lower shear blade.
1
Fig.18
► 1 . Upper shear blade
After installing the shear blades, apply oil to the shear
blades by referring to the section for shear blade
maintenance.
After installing the shear blades, adjust the cutting
depth by referring to the section for cutting depth
adjustment.

OPERATION

CAUTION:
Always hold the tool firmly. And
keep firm footing.
CAUTION:
Do not put any of your body parts
near the shear blades during operation.
CAUTION:
Before use, inspect if the shear
blades, blade bolts or other parts are not worn or
damaged. Replace worn or damaged parts for safe
operation.
NOTICE:
If the shear blades are stuck in a
branch during operation, do not twist the tool.
Release the switch trigger and turn off the tool,
and then pull the shear blades straight out slowly
from the branch. Otherwise the shear blades may
be damaged.
NOTICE:
In case you cut too thick branch or
something too hard, the overload protection
works and the tool stops. In this case, release
the switch trigger and turn off the tool, and then
pull the shear blades straight out slowly from the
branch.

Using the holster

Pass the belt through the opening of the holster as
shown in the figure, and then put on the holster.
Fig.19
Insert the tool into the holster. You can fix the tool with
the strap. Before inserting the tool into the holster, close
the upper shear blade by pulling the switch trigger more
than 3 seconds, and turn off the tool.
Fig.20
11 ENGLISH