Installing The Hardware And Software Components - Siemens SIMATIC MV320 Manual

4 Installation and commissioning
6. Connect the MV320 handheld reader via RS232 to the ET 200SP
communication module CM PtP.
Note The following Figure shows the cable for a point-to-point connection between a
communication module and a communication partner.
ET 200SP CM PtP
The following Table provides an overview of all IP addresses used in this example.
Assignment of static IP addresses is assumed.
Table 4-1
Component
CPU 315-2 PN/DP
ET 200SP
Engineering station
The subnet mask in all network components is 255.255.255.0.
4.2

Installing the hardware and software components

To load the hardware and software components, proceed as follows:
Install the hardware and software components
description in the operating manuals of the respective components
(Section
7. Connect the hardware components as shown in
8. Extract the file "109474684_ET_200SP_CM_PtP_MV320_
PROJ_V17_V20.zip".
Note This compressed file contains the V17 project.
Reading QR Codes with SIMATIC MV320 via ET200SP CM PtP
Article ID: 109474684, V2.0,
SIMATIC MV320
IP address
192.168.0.1
192.168.0.3
192.168.0.10
7.2).
10/2021
Description
S7-300 CPU
ET 200SP distributed I/O system
STEP 7 V17
(Table 1-1) according to the
Figure 4-1.
16