Table of Contents
Advertisement
Hardware Overview and Setup
3 Hardware Overview and Setup
3.1 Getting Started
The following steps must be followed in starting board operation using the default APPSFPGA code installed at
the factory:
1. Connect the desired DMD EVM to the DLPLCRC410EVM using the provided flex cables. A single flex cable
connects J13 to either the DLPLCR70EVM, DLPLCR70UVEVM, or the DLPLCR65NEVM. Two flex cables
attached to J13 and J14 are used for the DLPLCR95EVM and DLPLCR95UVEVM.
2. Confirm all SW1 switches are in the OFF position. Confirm all five J2 jumpers are in place. If using a
DLPLCR95EVM and DLPLCR95UVEVM confirm J10 is installed.
3. Connect a 5 Volt, 6 Amp power supply to either power input connector J12 or J18 (not both) with the power
supply OFF.
4. Turn the power supply ON and then slide SW4 to ON. D2 and D3 briefly illuminates to indicate the
APPSFPGA and DLPC410 Controller are being configured. Once configuration is complete, D2 and D3
turns off and D16 and D17 illuminates green. D9 flashes green at 1 Hz. D10 displays green. From this point,
the DMD repeatedly cycles through several test patterns.
To stop operation:
1. TI highly recommends to float the DMD mirrors to set the mirrors to a flat state before powering off. Press
SW3 to float the DMD.
2. Turn power OFF.
3.2 User Connectors and I/O
This section describes the use of each DLPLCRC410EVM Controller Board external connector and provides pin
out information.
Figure 3-1
J3, J6
GPIO
Connectors
J8
DLPC410 Mictor
Connector
®
12
DLP
Discovery™ 4100 Development Platform
and
Figure 3-2
show connector locations on the D4100 controller board.
H1 JTAG
Figure 3-1. DLPLCRC410EVM Controller Connectors (Top View)
Copyright © 2023 Texas Instruments Incorporated
J13, J14
DMD Flex
Connectors
DLPU040B – OCTOBER 2016 – REVISED MARCH 2023
www.ti.com
J1 USB
Connector
J9
APPSFPGA Mictor
Connector
J12, J18
Input Power
Connectors
Submit Document Feedback
Advertisement
Table of Contents
