ACR Electronics OLAS Extender Setup

Setup
FOR FIRMWARE VERSION 2.0+
Before first use fully charge your Extender by connecting to a 5V USB power supply using the charging lead provided, it
Connecting your Extender
1. Set up your existing ACR OLAS system using the
Core/Guardian.
2. Hold the Extender next to the Core/Guardian and press the
button once on the Extender; the switch light will illuminate
red.
5. If the ACR OLAS mobile app is connected the Extender will
be visible on the homepage
6. For future operation the Extender will automatically
reconnect to the Core/Guardian. However, it is good to check
on your ACR OLAS app that the Extender is connected as it
may have run out of battery if not continuously connected to
a power source.
will take 3 hours to charge from flat.
Extender
Disconnect
1234
MOB
www.acrolas.com
3. After a few seconds the light will start to flash once every 4
seconds to indicate that it is connected.
4. The Core/Guardian will beep twice to indicate connection
has been made.