Wireless Network Projection - Epson PowerLite 1940W User Manual

8. If necessary, select IP Settings and press Enter.
9. Select your IP Settings as necessary:
• If your network assigns addresses automatically, turn on the DHCP setting.
• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press Enter.
10. To prevent display of the IP address on the standby screen, turn off IP Address Display.
11. When you finish selecting settings, select Complete or Setup Complete and follow the on-screen
instructions to save your settings and exit the menus.
Parent topic:

Wireless Network Projection

You can send images to your projector through a wireless network (PowerLite 1945W/1955/1965). To do
this, you must install the optional EPSON 802.11b/g/n wireless LAN module, and then set up your
projector and computer for wireless projection.
Wired Network Projection
45