Haier H2F385 F Series User Manual page 19

EN
4.14 High temperature alarm
This freezer is
mode, if temperature display incon shows"HH" with beeps, by touching any key, the beep
will stop, but temperature display incon keeps blinking, that means temperature in the free
-zer is too high. Please check if the door is tightly closed or if large amount of warm food
is put inside the freezer. After a period, temperature display incon will stop blinking. If it
does not stop blinking "HH" for a long time, and beeps that are manually cancelled rings
again, please contact aftersales service.
4.15 Error indication
is faulty. In this situation, the freezer could still freeze food but user should contact aftersales
service as soon as possible for optimal control of the freezer.
4.16 Energy saving tips
Make sure the appliance is properly ventilated (see INSTALLATION).
Do not install the appliance in direct sunlight or in the near of heat sources (e.g.
stoves, heaters).
Avoid unnecessarily low temperature in the appliance. The energy consumption in-
creases the lower the temperature in the appliance is set.
Allow warm food to cool down before placing it in the appliance.
Make sure the door always closes correctly and unimpaired by food position. Keep
door gasket clean.
Defreeze frozen food in a fridge.
Clean the rear of the appliance regularly. Dust increases energy consumption.
positioned in the appliance on factory-fresh condition, and food to be placed without
blocking the air outlet of the duct.
1
2
with high temperature alarm. In freeze mode or Super Freeze
5.1 Removable door shelves
5.1
The door shelves can be removed for cleaning:
1
Place hands on each side of the shelf, lift it upwards (1)
and pull it out (2)(Fig. 5.1).
In order to insert the door shelf, the above steps are
carried out in reverse order.
5.2 Glass shelves
5.2
1.
2. To reinstall it, put it on the lugs on both sides and
edge (1) and pulling it out (2) (Fig. 5.2).
push it to the most rearward position until the rear
4-Use
it indicates that the freezer
.
17