Epson Stylus COLOR 740 Quick Setup Instructions

1
1
Set up the printer
Set up the printer

1 Unpack the Printer

Remove any tape and packing material from the printer as
described on the Unpacking Sheet in the printer box.
Make sure you've got a cable to connect the printer to your
computer and these items:
paper support
black ink cartridge
printer
Printer
Basics book
Place the printer near your computer and an available
grounded outlet, but avoid areas:
with high temperature or humidity
in direct sunlight or dusty conditions
near sources of heat or electromagnetic interference,
such as a cordless telephone base unit
Also be sure to check the System Requirements and follow
all the Safety Instructions in your Printer Basics book.
Note:
If you need help as you set up your printer, see
"Problems? Need Help?" in the Printer Basics
book.
color ink cartridge
printer software
CD-ROM
®
EPSON
media pack
2 Put on the Paper Support
Insert the paper support into the slots at the back of the
printer's sheet feeder.

3 Install the Ink Cartridges

1. Plug the printer's power cord into a grounded outlet.
Caution:
Don't use an outlet that can be turned off by
a wall switch or timer, or one on the same
circuit as a large appliance. This may disrupt
the power, which can erase the printer's
memory or damage its power supply.
2. Remove the ink cartridges from their packages. Then
remove only the yellow part of the tape seal on top,
as shown. Don't pull off the blue portion or remove
the clear seal on the bottom of the cartridge.
black car tridge
Caution:
Use the ink cartridges packed with your
printer the first time you install them or your
printer won't charge ink properly. You must
remove the yellow tape seal from the
cartridge or you will permanently damage it.
Don't try to remove the clear seal from the
bottom of the cartridge; ink will leak out.
color cartridge
Open to continue