Zanussi ZITN641K User Manual page 47

Problem
You can hear a constant beep
noise.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
The heat setting changes be‐
tween two levels.
The control panel becomes hot to
the touch.
comes on.
comes on.
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
Possible cause
You touched 2 or more sensor fields
at the same time.
There is water or fat stains on the
control panel.
The electrical connection is incor‐
rect.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
Power management operates.
The cookware is too large or you put
it too close to the control panel.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware does not cover the
zone markings.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The information about
guarantee period and Authorised Service
Centres are in the guarantee booklet.
Remedy
Touch only one sensor field.
Clean the control panel.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Refer to "Daily use".
Put large cookware on the rear zones,
if possible.
Refer to "Daily use".
Put cookware on the zone.
Make sure the cookware covers the
zone markings fully.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
ENGLISH
comes
47