Advertisement
Quick Links
Models:
Contour36
Contour42
Mesh Door Kits
These meshdoor kits have been tested for use with specifi c Hearth & Home Technologies products. Check with your local
building code agency before you begin installation to ensure compliance with local codes, including the need for permits
and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarifi cation of any of
the instructions contained here, contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you, please
visit www.hearthnhome.com.
NOTICE: Frame assembly must be installed prior to fi nishing
front of fi replace.
CAUTION! Risk of Cuts/Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
WARNING
Hot screen/mesh and glass doors will cause burns.
•
Do not touch screen/mesh or glass doors until cooled
•
NEVER allow children to touch screen/mesh or glass
doors
•
Keep children away
•
CAREFULLY SUPERVISE children in same room as
fi replace.
•
Alert children and adults to hazards of high
temperatures.
High temperatures may ignite clothing or other
fl ammable materials.
•
Keep clothing, furniture, draperies and other fl ammable
materials away.
Hearth & Home Technologies • Contour Mesh Doors • 4017-238 Rev C • 08/08
Note: An arrow ( ) found in the text signifi es change in content.
HOT SURFACES!
Screen/mesh, glass doors and
other surfaces are hot during
operation AND cool down.
NOTICE: All fi ngerprints and smudges must be wiped clean
from the viewable surfaces of the door kit prior to the initial
burning of the fi replace. If this is not done, these prints and
smudges will be cured into the fi nish and set for the life of
the fi replace. To keep the fi nish looking its best, gently wipe
with a soft cloth and if desired, soap and water. Never use
thinner or abrasive cleaners since these products will damage
the fi nish.
Contour Frame Assembly
Contour Mesh Doors
Figure 1
Contour Mesh Door Kit
Installation
Instructions
Lower
Grille
1
Advertisement
Related Manuals for Hearth and Home Technologies Contour36
Summary of Contents for Hearth and Home Technologies Contour36
- Page 1 Installation Instructions Models: Contour36 Contour42 Mesh Door Kits These meshdoor kits have been tested for use with specifi c Hearth & Home Technologies products. Check with your local building code agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspections.
- Page 2 Circulating Fireplace CAUTION! The mesh door kit is heavy. We recommend two installers to put the frame assembly in place. A. Remove the existing screens from the fi replace: • Remove one screw in each of the screen rods behind WARNING! Risk of Fire! Do not place combustible materi- the door track.
- Page 3 Door Track Noncombustible facing butted to the hood of the frame assy Noncombustible facing butted to the edge of the frame assy Screen Rods behind Door Track Figure 4 Finish to Outside Edges of Frame Assembly Figure 2 Remove Existing Screens and Door Track Frame Assembly (front view) Hinge...
- Page 4 Handle Alignment The bars (straight and arched) of the doors may need to be loosened and adjusted to align door handles when fi nal fi t up is done. • Open doors. Loosen (but do not remove) the two phillips head screws securing each bar. •...