Operating Instructions - NewAir G56 Owner's Manual

OPERATING INSTRUCTIONS

IMPORTANT!
This heater must be installed on the floor only.
Prior to operating the heater, ensure the electrical receptacle is of the
configuration and capacity appropriate for the heater. This heater uses 240 volts.
The cord has a plug as shown below. No adapter is available for this blade
configuration, and none should be used. The type of receptacle is a 240-volt
rounding receptacle (NEMA 6-30R). When properly installed, it provides a
ground connection through the cord to the heater to protect the operator from
electric shock.
Receptacle: NEMA #6-30R
240V 23.5 Amps
Your heater is equipped with a thermostat. The thermostat function controls
the temperature output.
• Turn the unit on by turning the thermostat control knob away from the LOW
position (clockwise).
• For faster heat-up or to increase the heat output, turn the thermostat
control knob clockwise all the way to HIGH.
• To decrease the heat output, turn the knob counterclockwise.
• Once the room reaches the desired temperature, slowly turn the thermostat
control knob counterclockwise until you hear a "click." This sets the heater
to cycle ON/OFF to maintain the desired heating temperature for energy
efficiency.
www.newair.com
Plug : NEMA #6-30P
240V 23.5 Amps
EN
10