Electrical Connection; Cable Shield; Signal Part - ABB Contrac LME620-AI Operating Instruction

Electrical connection

4 Electrical connection
Each actuator requires a Contrac electronic unit which is loaded with the type specific-software.
Carefully consider the instructions for the electronic unit and compare the data labels of the
actuator and the electronic unit in order to ensure a proper hard- and software assignment.
4.1

Cable shield

4.1.1

Signal part

Fig. 5: Fitting the shield
1. Remove approx. 2 cm of cable sheathing (3) from the end of the cable.
2. Separate the shield and peel it back to its inner sheathing (4).
3. Push the cable through the cable gland and fasten with clamp (1).
4. Make sure that the shielding is touching the clamp and the electronic unit housing (2).
14 LME620-AI/-AN (Contrac) 42/68-273-EN