Mpeg Select Menu; Program Field - Motorola DSR-6000 Operator's Manual

MPEG Select Menu

This menu allows the user to select which service is displayed at the video and
audio outputs by specifying the MPEG program number. Press the 56 buttons
until the MPEG Select menu appears. The MPEG program number can be used
instead of a virtual channel, but only if the DSR-6000 is already tuned to the
appropriate L-band or ASI input signal.

Program Field

Press the 4 button until the cursor is at the Program label, and press the ENTER
button to move into the field. While ensuring that the cursor remains on the up/
down symbol, press the 56 buttons to scroll throughout the available MPEG
programs. (If the current L-band or ASI input signal contains four MPEG
programs, then only four MPEG programs appear in this field.) Press the ENTER
button to confirm the selection.
This field also provides a second method for selecting the MPEG program. Use
the 34 buttons to select the digit to change and then, while the cursor is on that
digit, press the 56 buttons to display the required value. Repeat this process for
each applicable digit.
The DSR-6000 displays warning messages for the following conditions:
• A warning message is displayed when the user changes from a virtual channel to
a MPEG program number. Press any arrow button ( 3456 ) to back out of the
field and leave it unchanged. Otherwise, press the ENTER button to proceed.
• A warning message displays when an MPEG program number is selected
which does not exist.
Press any arrow button ( 3456 ) to back out of the field and leave it
unchanged. Otherwise, press the ENTER button to proceed.
MPEG SELECT Program
E 00000
CAUTION: Changing to MPEG selection mode
Press E to continue or to stop
CAUTION: Program ddddd does not exist
Press E to continue or to stop
33